Vibrating plate

Tamped vibrating plate - Poma RP 220

For traction vehicles with three-point joints, hydraulic jack, (Cat. I, Cat. II).

Is the ideal accessory attached grader Poma SK 225.

It's used for compacting roads and ancillary land by attaching two tamped plates to the back. So, additional smoothing of the road occurs immediately. Due to the splited construction process, the machine adapts to the higher form of auxiliary roads. The drive shaft is carried by belt transmission with 3 parts. The two vibrating plates are displaced to each other by 180 degrees, so it is guaranteed uniform vibrating effect of the plates. Prevention system against multiple vibration mounted on the port and stops transferring to the drive shaft.

Ideal compacting machine for road construction, landscaping and ancillary roads.
Technical Data:
working width: 2200 mm
frequency: up to 50 Hz
drive: Cardan shaft, 540 rpm.
compaction force: at 2500 rev/min: 2x25 KN
binding to the tractor: hydraulic in 3 points, rear, cat. I and cat. II
working speed: 400-2000 m/h
weight: 830 kg


Tamped vibrating plate - Poma RP 240

For tractors with 3 points hydraulic system, cat. II at 80 hp.

Operation of Poma tamper with 3 plates is achieved by vehicle's hydraulic drive system. The drive motor is directly connected to the shaft that provides vibration. There is no V-belts, such failures are much rarer. The vibrations are damped with rubber pads are very resistant to wear. The plates are rounded in front and level the surface. The road construction is intended to achieve EV2 values with as few turns as possible.

Ideal compacting machine for road construction, landscaping and ancillary roads.
Technical Data:
working width: 2400 mm
number plates: 3
oil required: 50 l/min., 180 bar
speed vibrating plate: 2000-2500 rev/min.
frequency: 33-42 Hz
driving force: at 2500 rpm: 25 KN/plate
binding to the tractor: front and rear cat. II
working speed: 1-3 km/h
weight: 1250 kg
webpage creation, web production, web storage: WebStarter